"NOTE: The Selector Watchdog LED should be ON CONTINUOSLY DURING SET UP. If a fault occurs, the LED WILL TURN OFF. SLF Fault Flag will be displayed on the FAST. If this occurs, press SEL,FLT and E to display the fault." Msd said, "The selector led stops blink at that time." That time being when the car is on the down limit, ready to learn, and does "stops blink" means it's now on continuously? The LED should be ON. When the scan is complete and once the car comes off of the up limit, the LED begins to blink, then press SEL-PAR-0-SAV. The Selector then should say, RDY. If not, you gotta problem. To check the scan IF saved, press SEL-E and a value should be displayed which has been saved.
Original EEPROM chips in a different board? Check for bent pins at the sockets.
Last edited by elmcannic; 04/23/15 08:05 PM.