0 registered members (),
14
guests, and
3
spiders. |
Key:
Admin,
Global Mod,
Mod
|
|
|
|
|
1
|
2
|
3
|
4
|
5
|
6
|
7
|
8
|
9
|
10
|
11
|
12
|
13
|
14
|
15
|
16
|
17
|
18
|
19
|
20
|
21
|
22
|
23
|
24
|
25
|
26
|
27
|
28
|
29
|
30
|
31
|
|
|
Forums13
Topics6,532
Posts36,953
Members8,461
|
Most Online117 Jan 16th, 2020
|
|
|
#20046 - 03/30/17 02:20 AM
KCM 831 with 16L drive
|
Joined: May 2013
Posts: 224
Jcjmowrey
enthusiast
|
enthusiast
Joined: May 2013
Posts: 224
Atlanta ga
|
When I get to the job, the fault buffer is completely filled with mostly 01 08 drive /tacho faults with a few 00 36 faults. I can clear buffer and it will run for hours flawlessly and not log any faults. When I go back a few days later the buffer is filled again. The maintenance guy says the unit has problems leveling but I've never seen it. I see the 01 08 fault can be caused by the tach, the brake not picking, the load weigher, etc. Has anyone had a similar issue and what is the most probable cause?
If all else fails, read the instructions
|
|
|
#20052 - 03/30/17 11:01 AM
Re: KCM 831 with 16L drive
[Re: Indirtwetrust]
|
Joined: May 2013
Posts: 224
Jcjmowrey
enthusiast
|
enthusiast
Joined: May 2013
Posts: 224
Atlanta ga
|
I didn't check subcode but will tmrw. For some reason I always forget those until after I've cleared faults. I'll also check rubber tire.
If all else fails, read the instructions
|
|
|
#20053 - 03/30/17 12:07 PM
Re: KCM 831 with 16L drive
[Re: Jcjmowrey]
|
Joined: May 2013
Posts: 224
Jcjmowrey
enthusiast
|
enthusiast
Joined: May 2013
Posts: 224
Atlanta ga
|
Do I just press select/accept button again once I'm looking at the fault to get the subcode?
If all else fails, read the instructions
|
|
|
#20054 - 03/30/17 01:17 PM
Re: KCM 831 with 16L drive
[Re: Jcjmowrey]
|
Joined: May 2011
Posts: 487
E-man
addict
|
addict
Joined: May 2011
Posts: 487
|
|
|
|
#20055 - 03/30/17 01:19 PM
Re: KCM 831 with 16L drive
[Re: E-man]
|
Joined: May 2011
Posts: 487
E-man
addict
|
addict
Joined: May 2011
Posts: 487
|
I've always replaced thosed O-Rings on the tach wheel even though I had one running once without an O-Ring. It broke and fell off and the car was still running. It was making a hell of a noise, I thought I had a cable off of the sheave.
Last edited by E-man; 03/30/17 01:27 PM.
|
|
|
|
|