Does anyone have a copy of Schindler Miconic GX prints for a 400A elevator on hand they could share? PM me or e-mail if you do.

Thanks.

On that note, I have some Miconic MX-GC prints. I think the MX-GC controller is not used in USA but is also used for similar MRL elevators (5300 series).

One thing I found interesting is that it looks like the MX-GC has DC 24V 'options' power supply(s) which gets a feed from the car lights main see below. Is this also the same configuration for the GX, or is a separate 120V feed run in US configuration to power the options supplies?



free ebay image hosting


Thanks.