Hey guys,

Our company just picked up one of the lovely Hydraulic MRL TKE Endura units, and there is no documentation/prints on site. Hopefully someone on here has something helpful, error codes and/or prints would be good to have. Willing to pay a fair price, the UIT tool is in the controller, so at least we have that much.

-Daniel

check PM

Can you send to me as well?

Never heard from Dano but PM me your contact info.

In my state the code says the location for log books and such must written in the firemans key box, they send out a red box to put all documents in so if you find that you might have prints.also if you look on the usb stick there is a manual but prints I dont remember.

The prints will be on the stick too

Did u check inside the cabinet on the hoistway side? Sometimes its in there.

I have 2 of these that were just flooded by a ruptured sprinkler line. The only issue I'm having is programming the new cpua board. Followed the manual exactly and no love. I am not a fan.

You might have corrupted software

Or this may take a higher version of IMS then the 2.4.x.x that is out on the market.