I have a customer who wants to add security to their 2 passenger cars with SPEC 60 (MRQ) controls. I know that the calls are serial and this will require some hardware to make it work. The existing job prints are missing some pages and I don't know for sure if there was anything in those pages that would have shown board addressing and wiring for the serial boards needed. I dug up an Otis article on how to program card reader operation for this type of equipment but I don't know if I can order a kit from Unitec for this project or if I have to piece meal it all together? Does anyone have a set of prints from a job that had security? I think I can use RS5 boards but I don't know what they should be addressed to either. Anyone's help would be greatly appreciated.
Hey Philly. I asked our local Unitec rep about that and he either didn't know about it or doesn't have the info for it. Do you happen to have a part number or any reference I can use to request that? I stumbled onto an article on the programming but I'm more concerned with the addressing of the RS's. Might you have any info regarding that or know how to get it?
Programming is too complicated to explain here, if you go ahead and sell the customer on it, i can try to help you over the phone. You obv need the tool.