So I exhausted all testing. I have 135v to coils. Up slow and up fast. They get energized but the pressure never builds past 180 psi. I need 240 psi for normal working pressure. No matter how I adjust the valve body pressure never builds. . It did come out of the pit however this morning but will not move on high speed or low speed from the level position at bottom floor . I’m going to replace the valve body .

The valve body is just by passing with out building pressure. I turned relief in all the way basically. Doesn’t change

I-2 valves should have only 1 of the 2 up solenoids energized. If you energize both, the valve will not adjust.

Car working great after replacing valve body. I don’t know what happened to the original .. as far as I knew it was working fine before motor went bad