Is the fujitec software for a swift futura job specific. We have a laptop w/ software and just acquired a new job that has this, wondering if we can use the tool for both jobs? If not, does thyssen even sell a tool w/ fujitec software anymore?
did you ever get an answer to this? i'm having the same problems now in a group of cars i just picked up in the same building. have rvm's and i have a laptop with futura but i cant communicate with any of them
When you say “ you can’t communicate with any of them”, do you mean you’re plugged in to the RS232 connector on any car, but your Wizard program won’t open at all? I was wondering if the baud rate might be set incorrectly.
Yes I have. The fuji mechanics in my area haven't been able to communicate with it in the past either. There is multiple cars in the building but they are on opposite sides of the building. I found online that it is possible they used remon or that I have to plug into the port on the back of the RVU unit. I haven't had a chance to get in there and try it yet. I think I'm going to try tomorrow.
yes i have wizard and it works on other futuras but these controllers were shipped directly to fuji's office i guess and we cant get into wizard when we plug in with any of the passwords