Who's Online Now
0 registered members (), 3 guests, and 0 spiders.
Key: Admin, Global Mod, Mod
March
S M T W T F S
1 2
3 4 5 6 7 8 9
10 11 12 13 14 15 16
17 18 19 20 21 22 23
24 25 26 27 28 29 30
31
Newest Members
Prairieelevator, Robot Rob, Montkone, Jevans, Clayshooter
8395 Registered Users
Forum Statistics
Forums13
Topics6,466
Posts36,640
Members8,395
Most Online117
Jan 16th, 2020
Previous Thread
Next Thread
Print Thread
#31607 - 08/23/21 03:44 PM Miconic A/M FHU Error  
Joined: Mar 2021
Posts: 14
ZeroProxy Offline
stranger
ZeroProxy  Offline
stranger

Joined: Mar 2021
Posts: 14
I have a Miconic A/M that has lost the FHU before and usually I would just connect the HHT and perform the fhu but this time around it’s not taking it, I can perform it and the car will run to the top and then the bottom but when it’s done it’ll still say FHU required and on stats>car>ftr it says 30:init FHU nvr bad. I check that it’s not missing any DZ flags and it is seeing the LU DZ LD on controller for each floor any suggestions I might be missing? I don’t have a lot of documentation on these.

#33073 - 05/14/22 12:57 AM Re: Miconic A/M FHU Error [Re: ZeroProxy]  
Joined: Oct 2021
Posts: 2
hernandez.alb@ Offline
Mech
hernandez.alb@  Offline
Mech

Joined: Oct 2021
Posts: 2
the MTV board battery backed ram has lost the table of learned floor position counts. check the onboard 4.8v battery. measure the voltage at the mtv board p17 connector. p17 is located just beneath p14 on the lower right hand side of the mtv board. the voltage at this point should be no lower than 5.00vdc. adjust ps1 power supply to get this value.

Hope this helps


Photo Gallery
PECCO PH5000 Overspeed Governor
Drive sheave
The best helper.
Rotary Oildraulic
Old Otis badge.
Brakes,Coil,Rotor
KONE MX10 repair tool kit
Powered by UBB.threads™ PHP Forum Software 7.6.0
Page Time: 0.027s Queries: 14 (0.007s) Memory: 2.6523 MB (Peak: 2.7857 MB) Zlib disabled. Server Time: 2024-03-28 09:38:25 UTC