Hello all, we had a tech out to troubleshoot an intermittent issue with doors he determined it was a bad relay on the wdpna board the shop ordered a new board I came to install it and now I’m not seeing all my door circuit. By the looks of the board I was just wondering if this is a board that needs to be programmed when replaced as it looks as though it would and not just a straight swap. Any help is appreciated After replacing the screen shows rear doors as closed and locked but front doors open even though physically closed and shows 82 after doors. When I go to faults most recent is 01I 0033. I don’t have much experience with these units so any input is much appreciated.