I don't follow you, you can't access faults unless it throws a fault up? What is it you are trying to find, if you go into E on the menu that's where all the faults are logged, it only stores the last 99 so if you go into menu E press select E-1 select it will more than likely come up with 99 followed by the fault 0026 then you can scroll down to 98 and so on, when you are on a specific fault and press select again then you should see sub menu codes. To clear faults press menu until you see E then press select until you see E-1 then up to E-2 press select you should see E-2-0 press up until the 0 changes to 1 then select again that will clear the logger, then you can start seeing the faults as you start to run the lift, hope that's clear enough? I've sent you a PM message.
Dave ,