Yes I did promice to test with the OTIS MCS LCBII blinking messages

If I

Make a incorrect leave sequence from the car roof to landing I get blinking error TCI-lock. the correct sequence is open door, switch TCI off, close the door.

If I

Make the bolts of anticreep device active I get blinking message ACS is on

If I

Make both 1LS and 2LS active at the same time I get error 1LS+2LS on

If I

Make rope brake detect overspeed or fail selftest I get blinking message RBU-fault. TCI/ERO resets this.

If I

Make Light Beam Gate active I get blinking message LBG/CSP-2

If I

Make a learn run I get blinking message Learn Run...:)

If I

Cut Se signal so that the car can not start I get blinking message SE-fault. Your best bet is to check THB, door bypass, fuses, SKL...

If I

Activate fault output AHVS that is connected to OTS input I get blinking message OTS Lock

If I

Switch Car light Swutch off in machine room or drop CarLight Relay on top of car I get blinking message MCLS/SKL-3

Thats all the test for today....Good morning, and in case I don't see ya, good afternoon, good evening, and good night!