Ok all

We are experiencing intermittent shutdowns on an elevator with Swift 5000 Controls. We have no monitor in place to help assess faults, but do have a laptop with only gives us fault codes, which we can then interpret from the documents in the machine room. Here are a list of faults we are getting and a brief description of what we have done. After completing all the below we continue to get intermittent faults.

Fault 11: Limit Position Reference Error: Replaced the power supply, new terminal limit at basement level

Fault 43: Gate and Lock Limit: Installed new gate contacts

Fault 31: Car in next up mode:

Fault 18: Car Response Time Out: Replaced Module, Replaced BK Relay, replaced MC Relay, replaced BK Module

Fault 27: BK and MC relay; replaced both relays

After all of the above we are still experiencing intermittent shutdowns. Floors served B, 1-15.

A modernization of this elevator (as well as all others) is currently in the works, however, at a minimum of 6 months out

Can anyone help with the above issues?

Secondly, does anyone know if there is a auto call mode on this type of control system where we can block the doors from opening, and run the car without the doors opening?

Your help is greatly appreciated