Hey all! hoping someone has some insight on a 3 phase transformer I need for a Kinematics Research LTD, Series A controller. Who the hell is Kinematics? Good question. Near as I can tell, they were in business for a very brief time in the mid to late 80s, based in California. The control transformer they used in these Series A controllers were a 3 phase, multi volt primary, wired from the factory for 230 VAC incoming, and had 230 Volts, and 115 volts, coming off the secondary. There are no indications on the transformer any additional info, and the print only shows the primary and secondary voltages, with no power ratings, no anything. Hoping someone is familiar with these and can point me in the right direction to replacing this transformer. Sometime, like yesterday......