Hello everyone. Another Kone question. I have a unit that is slow to pick up the e brake causing intermittent issues on takeoff. For now I'll leave the faults out of it as I believe they are standard if the brake doesn't pick. On the adon 2 I get my e brake command from cpu as well as k464 relays on, but e brake command(adon) doesn't come on right away like it should. Which is the power for the brake module to pick the brake. This is consistent for each run as well as on inspection while pressing just a direction to pick the e brake only. I have swapped the adon out. Swapped brake modules just in case and no change. So far the only thing I have found is incoming power pushing 500vac while my transformer is for 480vac. Pushing all my voltages on the lce-rec high. Unable to change at this time( no taps). Any ideas are appreciated. Possible cpu change out? Not wanted due to older So I and would to be upgraded to the kcp version. Thanks Mike