Does anyone have anything more than the basic prints for Baxco? I’m working on a 5 stop Hydro but I’d take anything to help me figure out what this thing is thinking. This is seriously killing me. Door open Output is freaking out, it fires erratically then eventually just stays on. The inputs all look right and sent flickering with the open output. I know that the Open opto-coupler is being turned on by the logic on the board but now the whole board has been replaced. Unplugging the expansion board made it stop and the doors worked normally (car wouldn’t run though) so just got a new or repaired one and it does the same thing.