From the picture it looks like a Schindler Smart MRL?
In that case you dont have a DOD PCB where you can choose your type of door machine. So I think I would remove the 3 main power phases of the X400 plug on the SDIC PCB and use the relays ST-S and ST-O to generate my open and close signals to the Fermator door controller. Remember to connect the door open limit (KET-O XKET Pin 2-5) and door close limit (KET-S XKET Pin 3-4) signals to the plug XKET on the SDIC PCB. The Schindler controller is very sensitive about these signals. You can connect the door reopen signal from the door controller in the same plug (KSKB XKET Pin 1-6).