I know there is software dependent on which processor board is on front of the drive MCINV5ST, or MCINV6ST; then two different versions of each of these depending on induction or permanent magnet motor. Also without newer version IMS and with newer drive board, all adjustments will be entered with hand held drive service tool if you need new drive.

I'm not aware of job specific software. But one of the Accord drive sizes is obsolete, 60 amp? I believe, need to double check. In this case I think TKE is retrofitting to 10k Quantum drive.

I have also been told that on some drives (other than TKE) that there are OEM licensing agreements for preventing others from purchasing certain drive components, such as IGBTs. Not sure if that is true, or if this applies to TKE drive