I’ll try to make this short. When the controller powers up all I get is a flashing error light. The GCIO itself and the ASILOG have both been replaced. I’m thinking it’s the software but I want some expert advice on how to proceed. I don’t see anything in the manuals about the error light flashing. I have tried unplugging everything else from the ASILOG and I’m assuming that with 24v to X3-1-2, I should at least get a watchdog if the CPU and software are good. Please let me know if I’m wrong and it needs to see a drive or the LON board. The long card on the edge of the GCIO looks like just generic RAM so is all the software on this removable CONF FLASH chip? Can this chip be ordered from Adams with the GO # or does it have to be loaded with a CADI?