I've had sometime to work on this issue. I've gotten closer to a running elevator but am still having an issue.


My floor table needs to be ran, but can not due to controller not seeing the vanes. I have closely watched my vanes going through the readers and they are reading every single vane. I am a bit unsure exactly how this setup works, but what I am seeing happen with my meter, is that as I go through my voltage will swap from DC+ to DC- as it sees the vane and the holes. I have followed my voltage all the way from the car top, to the relay pilot board, through the CN6 connector, to the MSU, and it sees the voltage swap all the way to the MSU.

Doing my vane reader check, it only states

Last floor 00
Direction up or down depending on the direction traveling
Status bad. A:***


The only thing I am seeing is a voltage drop from 12.3vdc on cartop, to 11.8 at the MSU.