Bummer,
Seems this is vane reader issue is new right? Previously you did run a floor table, and there was no mention of it not being saved, so what’s changed other than tool type?
Both optic readers are set at “max”...is the car speed for inspection set to about 25fpm for the learn?
So when you inspect the car to the bottom and onto the DDL to start the floor table build, it won’t see any vane going up correct?
Yes previously was able to run a floor table, but somehow the table was lost. Im assuming with the swapping and changing of everything it was lost? That is correct that starting on my down directional limit, and all the way up to my up directional, no vanes what so ever are read using the vane reader check.
I have had ongoing issues with this elevator ever since taking it over 3 years ago.
