If you swapped the CPU the floor table and all the field programmable parameters are gone. The floor table is on a removable chip I think it is at U37. or U18, depending on the age of the install. You can also read read the vanes while making a new floor table. Every floor must say good as it goes past the vane. If one says bad that is the vane you need to look at.
That's the thing, every single vane, all 12, show bad. Like it is not processing in the CPU. That's while doing the vane reader check.
I attempted to use the old dallas ram chip but one of the prongs broke off taking it out of the old board.
