Has anyone tried to put the terminal emulator software for IMC CRTs on a laptop? Motion sent me to Ericom website but couldn’t give me much more info. The only Emulator on there that matched one of the ones listed in the original Computer Peripherals manual was WY-370 so I downloaded the trial for that. So far so good. Now I need to convert a 9 pin Dsub to an RJ11 plug. Does anyone know the pin out for this? There is an RJ11 to 25 pin diagram in the back of the old peripherals manual so I think I’m going to try that with a regular 9 to 25 pin adapter only not actually use the adapter, just wire from the 9 pin to RJ11. Any input on this would be appreciated.