I have an ongoing issue with a unit that will not stop at the intermediate floors only in the down direction when there is multiple calls latched. I am in a troubleshooting loop in the stopping circuit and have been all over this circuit. Basically if I have a down demand (XD picked) unit will always go to the lowest floor called and then run up to the floor it passed. I can manually pick S relay and get the car to stop as it should but as I go thru these prints, I don't see how it is possible to pick S with the combination of contacts that are required to pick to accomplish this. As I stated, car only does this in down direction. Up calls are functioning properly which lead me away from the floor switches plus I have monitored them while car is running. Any help is appreciated! Thanks