This Otis 2 stop has an issue, and I dont know what I am looking for. It blew out its packings. Filling the pit. My company repacked it. Jumped out the motor starter and got it level with the floor. But since, it will not run on inspection or normal. Wont take calls.

I have the blue tool. M-1-1-1 shows Nav M*
I have reset rams and the 2.2.3 reset.

My company was not the 1st to look at this unit tho, and I may have jumpers in the wrong spot or removed. Currently no red jumpers on controller board. All sitting in a nice pile in cabinet bottom. So no XDRO, XROP, XLOS, XLPS, SXL

controller has leds on for DZ. 5v. Ld1. Door closed. Gate closed. Heart beats or flashing Less for RSL, RING, CAN O, LD2, LD3.

Any ideas guys?