Thank you for the reply. How did you know to use “000” or “010” for that specific input. I know “000” normally means to turn off a parameter, but does “010” mean to turn it on? And does this apply to all other IO’s or just this one specifically?

I also attached two sheets. One is from a 2006 manual and the other from 1989. The controller I have was put in around 1990. So I’ve been going off of the 1989 manual. In that manual they have independent listed as IO #179.

In the 2006 manual they have it as 391, like you said. Should I go off of the 1989 or 2006 manual?