Thanks. IMs talking to controls except not the door board. Still waiting for a new door board to show up. DCL not changing state in the door I/O’s. But it does change state on the universal door board. Mostly door related errors. Car won’t run on auto but will on insp. Floor counts stored correctly by the encoder counts while running on insp are in the millions as the car runs up. At about the 3rd floor the count goes from 15million back to zero. I’m assuming it may need a new hoistway scan but I’m trying to figure out if it really need it or if there’s a way to force the system to accept the stored scan. Luckily we wrote down the floor counts for a reference some time back. I’m waiting to fix the door issues before proceeding. Best to see what clears up once the door boards been replaced. Thanks for,your response.