Prior to replacing the VEC, DS 5 (PWR FAILURE) over or undervoltage on the 5v,15v,24v from PS1
and DS 7(PREFOMANCE ERR) would come on but would not hold the LED on.
After encoder, ENC and VEC were replaced. I just get the normal DS1&2. DS12,13,14,15. When I try to run inspection DS11 (Drive Enable) comes on then off right B4 the Moving NO PULSES pops and WARNING DROPPED DRUN KRUN STILL ON. That should mean my drive and PWR supply is on point. So I'm leaning towards this 38 machine is bound up. Because there is not much left .