Installing a hydraulic package with Virginia controller - job has single phase coming in so we have a phase technologies solid state phase converter, motor is nidec 230v.... running up the motor is loud as hell, and after about 6-8 seconds my overload trips. Triple checked wiring of the motor with my Mfg and see no issues. When running up and measuring voltage between legs I have a drop on one set that goes down from 240 to 175 and another set goes down to 215. Mfg is at a loss and electrician isn’t much help. My knowledge of electrical and motors is not too advanced so I’m stuck. Not sure if this is a motor problem causing it or incoming power from the phase converter? Appreciate any help or suggestions