so i spoke to a few techs on both the motor side and phase converter side. sitting idle i was seeing 240 leg to leg all around, as i ran up i had two drops to 175 and 215 which i thought may be part of the issue. Speaking to the Converter tech he said this is normal it seems because it looks like the motor is pulling too many amps and the phase converter is actually designed so that it drops voltage if greater than 130 amps are being pulled. The controller manufacturer is now having me rewire the Motor Overload relay so that the T3 leg to the motor essentially by passes the overload. Apparently they think the electronic overload is having issues because of the way the phase converter is providing the 3 phase power... or something along those lines. Doesn't make much sense to me, the motor is loud as all hell when running too but apparently they think rewiring this overload will correct that as well.