I have a 2 stop 2003 Cemco Lula with Fire Phase 1&2. When the elevator is in recall and a hoist way door is opened the elevator continues to run. In normal operation the elevator stops running when the hoist way door is opened. In my hoist way door lock wiring at the controller I have a wire that goes to the circuit board to an unmarked terminal, I believe it is an output. When I remove this wire the elevator will stop when a hoist way door is open during recall but when the door is shut the elevator will not resume operation. I have to manually lower the elevator to the 1st floor to resume operation. I think its an issue in the programming or software. Has anyone ever seen this before? I know Cemco is out of business and getting new software or reprogramming is next to impossible. The elevator is shut down and locked out at this time.