Having some troubles with a hoistway scan on a DMC-I. Unfortunately power was off with a dead battery and it lost all the parameters. Ive got the CLC parameters inputted however when trying to do a hoistway scan it comes back as 0 pulses recorded. Ive tried multiple times using all the ports, tried lowering car a bit below the BDL, saving the values right away and also after running car down an inch before saving (using world electronics software) and nothing seems to be working.

I did have one attempt that it recorded pulse values for the floors, but it didn't show any value in the saved section.

I am also resetting selector and CLC faults before starting hoistway scan

The LED stays on the whole time, and starts flashing at the end once I make it to TDL. Car was running fine before a jack sync sensor had to get replaced (replaced and working now).

No selector faults after the run, but I do get an "attempt to save incorrect floor data" on the CLC which I'm guessing is due to no pulse counts being saved.

Any help would be greatly appreciated!