I am working on a Kone Resolve 20, (4 stop traction) the initial issue was the the elevator stopped working immediately after a shunt test. It completely lost itself and had several faults, the one that was the biggest issue was F017. I also found the door operator wouldn't do a learn run so replaced the board and did a successful learn run. The LCE also said the lift was at floor 63 (there are 4 floors) The fault still showed, I was able to run the lift on inspect and tried to do a learn run but the fault was preventing it, I found the rear DZ (B30) parameter incorrect (there are no rear doors) when I corrected it the F017 fault disappeared,
No faults are showing now but it now wont run on inspect to position for the learn. Any suggestions?