It won’t be on the job stick. I’ve never seen a door board come out without any generic software in it. What has to be loaded is a profile. The easiest way to do it, if the board is brand new from Vertical Express, is with UIT (6300HL1) there’s a menu in the board called Config with all the preset profiles in it. They do have a profile in them from the factory too, not sure but I think it’s a harmonic DC. You can also load a profile through IMS, I think that’s the way it shows in the door manuals. Just if you have newer IMS they put them in the wrong place. They’re in the Drawings folder inside your IMS folder.