All my board functions and power check out good. My status lights all are acting as they should . 240v to P1. No P3 connection. P4 pin 1 to 3 has proper voltage. 24v discrete input. My DCP voltage is correct. 24v when away from sensor. 0 v when on sensor. I can see values change on my service tool as I move door by hand. Service tool plugged into door board says SHD DED. I never get any voltage to my 3 wire motor connector. But I never get the board to say ready. As soon as I do a learn run from the buttons on top of door board it aborts the learn .