I would expect then that you’d get the same fault if the car tried to run up or level up. For some reason you aren’t getting a run command to the starter. MCC1 powers the starter, MCC2 and MCC3 pick to give the starter a run command. The 20-03 print I’m looking at has OLTS in CON25-1. The only other time you see “Viscosity” as the car status is when it’s on “Viscosity Overtemp Shutdown.” Usually form the OLTO input or MCF from the fault contact on the starter. It still just shows Viscosity for some dumb reason but if you put PCL in Remote Fast you’ll see which it is.