Here goes. Customer made a call today. He was painting around the 2nd floor hall button. Wanted to remove the button faceplate from the wall. It was stuck from layers of paint, so he used his knife to pry from the wall. When he did the plate fell off the wall causing the wires to unplug from the button and hit the floor. He then thought O Sh**! Well he went to another elevator and pulled out the wall plate to see how it was wired. He got the wires hooked up, but the elevator would not run. No joke. Ok when I got onsite there were 4 blown fuses, I f2, f3, f4, etc. I have completely removed the button and still blow f2, f3. Removed wires to button in hoistway. Still blow f2,f3. Unplugged clc, still blow f2, f3. Wondering about the rectifier or the capacitor in that circuit. Any ideas??