Hey guys . Had a late night call the other night to a bank of two 5 stop mce vcmf 1000's. Pre ibox. The number 1 car was not answering car or hall calls, so I head to the machine room to find a motor limit timer fault. Reset back to normal op but still not answering calls. Place car on mr inspect while I'm holding the down direction switch I get a rei redundancy fault. As soon as I let off it goes back to normal op. So I check my run enable relay and it it not firing nor is the drive on relay. In the middle of troubleshooting and checking voltages it took off and has been running ever since. I'm not too familiar with these controllers we only have a few on out route. Just woundering if anyone else has seen this before
