Otis 211 controller fault.

0 members (), 23 guests, and 2 robots.

Key: Admin, Global Mod, Mod

Forum Statistics

Forums13

Topics7,385

Posts40,939

Members10,040

Most Online3,137
Apr 9th, 2026

Print Thread

Otis 211 controller fault. #12319 10/14/14 02:26 PM
Joined: Apr 2012 Posts: 26 Oklahoma S ssharp newbie
ssharp newbie S Joined: Apr 2012 Posts: 26 Oklahoma	My controller is reading a TCI fault on the screen and will not reset. found that fuse F7 was blown but installed new fuse but can't reset elevator. I have no plans or manuals on this controller.

Re: Otis 211 controller fault. ssharp #12320 10/14/14 03:03 PM
Joined: Jan 2014 Posts: 736 R Rolly old hand
Rolly old hand R Joined: Jan 2014 Posts: 736	TCI is a mode of operation not a fault. Your in Top Of Car Inspection mode. If you blew a fuse you must have a short that took you to TCI mode. Bad travel cord or pinched wires, etc etc!!

Re: Otis 211 controller fault. Rolly #12408 10/21/14 12:37 PM
Joined: May 2012 Posts: 194 L Len member
Len member L Joined: May 2012 Posts: 194	Top of car switch contacts.have a tendency to short out..This will take out the fuse and generate ti fault on the mpu..

Re: Otis 211 controller fault. Rolly #12409 10/21/14 12:38 PM
Joined: May 2012 Posts: 194 L Len member
Len member L Joined: May 2012 Posts: 194	Top of car switch contacts.have a tendency to short out..This will take out the fuse and generate tCi fault on the mpu..

Re: Otis 211 controller fault. Len #12534 10/31/14 12:06 AM
Joined: Oct 2012 Posts: 36 T tony newbie
tony newbie T Joined: Oct 2012 Posts: 36	I had it and rotated the switch a couple times it came off...

Re: Otis 211 controller fault. tony #12682 11/10/14 04:20 PM
Joined: Apr 2012 Posts: 26 Oklahoma S ssharp newbie
ssharp newbie S Joined: Apr 2012 Posts: 26 Oklahoma	I have checked the switch and wiring but still have a fuse blower. I took the switch completely apart and ohm it out and it showed to be good. I can get controller read out to read normal run status but that's with the #346 wire unhooked in COP but car still wont run. Is the led light in the COP CPU board supposed to blink slow like the HRT light? My COP light is blinking rapidly.

Re: Otis 211 controller fault. ssharp #12809 11/22/14 11:29 PM
Joined: Oct 2012 Posts: 36 T tony newbie
tony newbie T Joined: Oct 2012 Posts: 36	did you find the problem

Link Copied to Clipboard

Photo Gallery

service tool laptop
by dunkdadrunk, February 4

rip orona
by epic_ecodisc, January 7

what controller is this?!
by Alex_ELMAN, December 4

HW PM
by Chris, January 13

Drive sheave
by jkh, October 10

The best helper.
by Adrian, August 8

Home Forums General Discussion Technical Questions Otis 211 controller fault.