Home Forums General Discussion Technical Questions shindler 3300

how can i use 3rd party access key card on shindler 3300

Just wire your card reader relay into the key switch on the cop and set it to a floor in the paremeters

Shindler 3300 has access called SASA
Cop doesn't has any key switch
how can i connect relay reader on cop and where
ThyssenKrapp @

Take off the COP and find input X-KEY then use relay from card reader to input signal and assign to a floor in parameters

thanks alot ThyssenKrapp
if i want to make card reader for all input calls on COP
what should i do ?

Either Buy the SAS system from Schindler or contact MODUSYSTEM and replace the COP with standard buttons using their driver board then you can do what you like with the calls

Would it not be easier to assign a pin code to all floors in the parameters using the existing software?

SAS system is very expensive
if i want to use 3rd party reader
what should i do?