LD 03 DOOR operator replacing board

0 members (), 34 guests, and 3 robots.

Key: Admin, Global Mod, Mod

Forum Statistics

Forums13

Topics7,385

Posts40,939

Members10,040

Most Online3,137
Apr 9th, 2026

Print Thread

LD 03 DOOR operator replacing board #38992 02/13/25 11:04 AM
Joined: Jan 2023 Posts: 11 J Jm21 stranger
Jm21 stranger J Joined: Jan 2023 Posts: 11	Good morning everybody, almost Friday. So i replaced a door board on a thyssenkrupp LD 03 door operator on a tac32 mrl hydro. I thought it was plug n play but not the case. If i hot the MDo or Mdc buttons the door jerks ridiculously hard but does not move smoothly. Is there any procedures im missing to program the board? Any help appreciated 👍

Re: LD 03 DOOR operator replacing board Jm21 #38995 02/13/25 08:53 PM
Joined: May 2015 Posts: 359 W wltr00 enthusiast
wltr00 enthusiast W Joined: May 2015 Posts: 359	The board needs to be programmed manually or by uploading a profile to the board through IMS.

Re: LD 03 DOOR operator replacing board Jm21 #39029 02/18/25 09:25 PM
Joined: Feb 2015 Posts: 60 Likes: 1 T TNHapa84 journeyman
TNHapa84 journeyman T Joined: Feb 2015 Posts: 60 Likes: 1	Do you have a UIT for the door board or IMS ? Be careful if it set wrong you could damage more. As set to ac or dc motor

Link Copied to Clipboard

Photo Gallery

service tool laptop
by dunkdadrunk, February 4

rip orona
by epic_ecodisc, January 7

what controller is this?!
by Alex_ELMAN, December 4

HW PM
by Chris, January 13

Drive sheave
by jkh, October 10

The best helper.
by Adrian, August 8

Home Forums General Discussion Technical Questions LD 03 DOOR operator replacing board