Home Forums General Discussion Technical Questions Schindler 400A

Anyone ever modernize one of these? Specifically which machine was used?

If the CW is adj. to the rails, I would use an imperial 540 series (the one that's directly interchangeable with the KONE Ecodisc), otherwise, I'd start over with a belted job like a 31/3300, 5000, 5500, evolution 200, or Gen3. Do go with EOX. If you could send a pic of the shaft layout, I could better help you.

If it's a short height, you could probably put an inground or above ground hydro in.

8 stop. Looking for something that’s non proprietary

Alliance Elevator Solutions might be an option.

Anyone have some good literature on these they’d like to share?

allianceelevator.net

Sorry Montana, meant a good manual on the 400 A