We almost sure that problem in is resolver, but when I open machine again we see resolver with white magnetic. In the site of Kone magnetic with black magnetis. I am not sure what is differnt. Do you know number part or differnt of magnetics?
#10734 - 05/16/1402:38 AMRe: problem with elevator KONE after change bearings
[Re: The supervisor]
I would call kone and have them fix it for you and ask what was wrong. We fix elevators for other companies and vice versa when ever it's a high priority job. Just fixed a st for schindler last week and put in a digital drive in a st for otis. We all need help sometime especially me.
#10735 - 05/16/1403:37 AMRe: problem with elevator KONE after change bearings
[Re: Kone D]
I do not know why, but whenever we call for service or parts thereof have not received any response or refused. Their only problem is that we're competition. We have not refused assistance.
#10806 - 05/24/1402:46 AMRe: problem with elevator KONE after change bearings
[Re: The supervisor]
Do you get (-----) on the display when the elevator reaches the top floor on a shaft learn?
What software version do you have on LCE?
Have you tried changing the motor type in the parameters to something different, to say MX 20 and then changing back to your motor for example MX 10 as this ill load preset parameters into your drive. this is use full if you have been changing parameters and need to start over.
Also may be worth checking tacho filter parameters and that 77 switches are not getting a false signal during set up, from something like a guide bolt.
#10842 - 05/26/1408:45 AMRe: problem with elevator KONE after change bearings
[Re: ThyssenKrapp]
Do you get (-----) on the display when the elevator reaches the top floor on a shaft learn? - YES
What software version do you have on LCE? - I am not sure
Also may be worth checking tacho filter parameters and that 77 switches are not getting a false signal during set up, from something like a guide bolt - WE checked.
The elevators work in group with two same elevators.
#10844 - 05/26/1406:03 PMRe: problem with elevator KONE after change bearings
[Re: The supervisor]
When we mafe parameters got angel mashina of 0 and next we back of previuse number. The elevator "want" we adjustmebt the loading devise. This is normal?
#10889 - 06/01/1405:12 PMRe: problem with elevator KONE after change bearings
[Re: The supervisor]