Home Forums General Discussion Print Talk Cheney HANDiLiFT

I just went and fixed a 3 stop Cheney HANDiLiFT with electric door strikes. One of the micro switches was sticking. But, there is no prints on the job.

Any chance someone could provide me with a print?
WD 1806-HL

If you are still looking I have a print for a 3-stop Cheney HandiLift from the late 80's. Can scan and attach or email as you wish.

[email protected]
Thank you Sir!!

Thanks [email protected] I have a new potential customer if I can find a print for this thing...any thing you has is better than the nothing I have...be safe!!

Sorry was not on the forum for a bit but will get the print up tomorrow for you via your email. Need to scan on a larger scanner than I have at home since it is a two-page print.

I've sent the prints I have to your email this morning.

OK -got my HandiLift problem solved here thanks to the motor schematic I got from Baldor.... sometimes the obvious is not so obvious! The last problem was the thermal breaker on the motor had tripped. The reset button is in a difficult to reach spot and it was not clear from visual inspection it had tripped. A firm push and the whole thing is back to working.

Thanks Eric!!!