I believe it is a boot leg tool from a former employee of TK. It has the FAST Tool, IMS, IMS for CPUA, and CADI tool on it.
It is not laid out like a FAST tool though and is on a laptop. Can't get any support/help for this particular tool.
Front and rear door operator, part number 6300FX3, it is on a DMC1 installed in 98/99.
I am going to get a Freedom tool for it. I have the Miprom Freedom tool and it works great...
I talked with a guy at World and he said to check voltage between pins 1 &4 on the T5 connector on the door board. It should read 5v (this is to rule out an encoder issue). Cant get a Pulse count on the front or rear door.
Doors do open and close as demanded but is very hard, I'm surprised the gate hasn't fallen off yet!
