Hi all. New to your forums. Need some help. I am a fix-it-up guy at our church. Our TK elevator recently stopped working. I can get the motor starter to flash a message by cycling the power. It says something like, 'line in low, motor stopped, control voltage low.' And then I can test the terminal block on the side of the starter and on the line that says "control voltage" I get nothing. So I trace the wire back to a connector on the main card (IOA.) From here I am not able to troubleshoot the card itself. So I was wondering if anyone has any suggestions as to what to look for on the card or upstream of it that would cause the control voltage to stop to the motor starter? Fuses (checked the 4 I found on the card)? Are there safety switches in-line inside the car or hoistway before the starter control voltage? Relays on the card? ............ thanks. J
