have a 4 car group, building did some kind of generator/ electrical work this weekend. only 1 car is running now, the other 3 cars say no KPWR switch. INIT
so after a little investigating and poking around, i came across the ACTIVATE feature, I Activated KPWR, and kpwr came on and i could give it calls and it would run, so i did this on the other 2 cars as well, and same thing they all run,. so i started looking into the inputs from status panel, in the car that was running normally, i can see the status panel board inputs, but the other cars, when i go to view the io, it says board not active. so any way, i was running out of time, and I'm no expert, so i decide to wrap it up, and try again later. i again went to ACTIVATE feature, and deactivated the KPWR override, but now the PWR relay stays on, and i can give them calls etc. now under operation, it says BLOCK OPERATION under the 3 bad cars, and the good car says normal. seems like some kind of communication problem now between cars. any ideas? going to do some reading tonight to try and get some insight
