Another thing you could try if possible would be to decouple the motor from the gearbox (ie no load) and then temporarily wire it to the correct source voltage thus bypassing the drive. While you would have exercise caution and have someone standing by the mainline this would allow you to test your motor configuration. Verify your no load current matches the data tag. Once this is done and you are certain your wiring is correct then try to incorporate the drive. Presumably, if you are running open loop which on the torqmax drive you have the one encoder switching parameter set to zero I think it's like LF 27 but I am not sure right this minute, you might need to play with your slip frequency adjustments. Having a very high slip ratio will be like trying to move a standard shift car with the clutch not engaged. The torqmax has quite a few parameters that can screw you up if they are in the wrong spot.Make sure everything from about LF2 -LF30 is exactly right. Also verify your pattern scaling is set at something other than 0%. This may not apply to you but it does on some versions of MCE stuff.
