Does anybody have adjusting information on 62 & 70 UCL controls? I inherited two simplexes, 500 fpm gearless 2500#. Car was seriously undercompounded and not running any where near speed. I found that one of them wasn't pulling in VR. I located a wire that was left disconnected when a generator repair was performed many years ago. Of course, when this was left off, this necessitated someone readjusting various taps and shunts for the series field and the accel/decel circuits. After reconnecting the wire, VR started working, but the car is now overcompounded and slightly overspeeding in one direction. I could use a generator print showing the series field connections and orientation and an adjustment procedure for this control. I appreciate any assistance.
