Greenpants has been around the block a couple of times. I first ran into this on a elevonic 401, the ac end of generator burned up and it was rewound. the repair crew hooked up the wiring per the dope sheet only to encounter vics problem. after going through the nema wiring diagrams it became obvious that the windings were not labeled the same as the original otis set up. we just rewired per nema standards and all is well. I have had this problem come around about a half dozen times in the last few years. as soon as you show up on an otis job with rewound ac motor, and they cant get it to run, you will look like a hero when you rewire it to nema standards. this is a good one to remember, as it will happen again.
