Safety processor took a crap, couldn't configure it so we replaced the cpua card, downloaded software from an identical job that tk left the usb stick on. Now our hall calls wrk, ph1 works doors work. We just can't get anything out of the COP. No door open door close, ph2 fs and won't latch calls from the car.
I have attached a picture of the fault we get when I issue a DCN command in IMS.
Also, where on the hell is the CN board? The only boards I can find are the iod, cpua, hnb, cwil, and s24 board. Where is the CN board!!!!! Thanks everyone
The job software is unique to each job, .cfg file. Looks to me like it is looking for a second car node, usually used for security. Call me, I should have some time today to get you back on solid ground.
